Vacuum loader - container with RN 3002 as full level detection.

The Challenge

Vacuum loader is designed for special local works as : gravel removing, dry or wet earth, removing of half liquid or liquid material, oil product, removing of gravel without injury of engineering nets, cleaning of drainage tunnel, drainage entrance, removing of ecological accident result. Each vehicle is equipped with a special container. Container Is designed for primary separation of vacuumed material and for its collection. The tank is fabricated from steel, externally reinforced with U – sections, and is dimensioned for absolute vacuum. Material unloading is made by container tipping when rear door are open. The air stream goes through pipes to filter unit of fore machinery part.

Our Solution

Datas from the container, including information about the container's fill level, is sent to the driver's cab. Our paddle switch RN 3002 was used for the full level detection. Thanks to the rope extension, the sensor was protected from lateral loads and falling rocks. The Teflon seal provides additional insulation and allows the sensor to operate in both positive and negative pressure conditions.

Our Product